Thingiverse
Ender Filament Coloring Guide
di Jeoncs
3
Download
4
Likes
0
Makes
I've been coloring filament for a while to save on having to buy special colors for one offs. Normally I take and snip part of a sharpie insert off and spool a certain amount through the felt. I made this little guide to mount on the back of the Z-Axis on my printer. You snip off about 10mm of insert and close it in then run the filament through it. It will color as it goes. Being closed off inside helps to keep it from drying out as fast as well. Just take it out and use it like a normal filament guide if you don't want it colored. I used the existing Z axis bolt and 1 small m3 screw
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
