Ender Snap-on Spool Holder

This is an enlarged spool holder which should fit the Ender's stock spool holder as requested by an instagram follower. I haven't tested this, so please refer to the dimension sketch if you have doubts about the measurements.

As per request, I used different bearings:
ID (d): 8.000. OD (D): 22.000. Width (B): 7.000.

Please check the ID of your spool against the dimension sketch before printing. Due to the bigger size of the holder, smaller spools might not fit.

For instructions please refer to [my original spool holder](https://www.thingiverse.com/thing:4725739). Let me know if you have any questions :)