Ender Spoolholder

This spool holder was designed a few months ago (I have gotten a lot better at printing since then) I would suggest printing it with at least 3 perimiters and about 35% infill, support needs to be used at overhangs starting at 50 degrees.
Print the files in the orientation as shown in the pictures.


You will need:
2x 608 ZZ bearing (regular skateboard bearings)
2x axle
1x Spoolholder
1x Bayonet Fitting Ring
1x Shim

If the spool holder is too loose you can use the scaling tool in your slicer to scale up the 2mm shim in the Z axis a few percent, if its too tight you can scale it down and make it fit. its also possible to fit an O-ring, works just as fine.

I'd love to see pictures if someone makes this spool holder!