Ender Table Brace Secure Base Mount

My Ender 5 Pro wobbled ever-so-slightly, even with frame supports. This mount\brace grabs the lower frame and allows me to fasten it to the table below. This single piece snaps on snug and is small enough in width to fit into small areas but thick enough to be secure. Now I have virtually 0 wiggle while printing. (I do have frame supports)

I printed mine with .28 layer height, .45 layer width, .57 infill width, 35% infill, no supports(though I have adequate cooling and it may be required for some who can't print over 45 degrees. 28 minute 15 second print.

Cheers,
`tekmouse