Thingiverse
Ender3 Control Board USB Retainer
von IamBrinks
3
Downloads
3
Likes
0
Makes
Had problems with Klipper, endless MCU failure errors. After installing this, no problems.
Fits slandered Ender3 control case, push into slots underneath, insert USB, cable tie together, Bobs your uncle.
They each hold each other in place.
If you want to use the cable holder the holes are sized to take 3mm thread inserts, you will need your soldering iron
Fits slandered Ender3 control case, push into slots underneath, insert USB, cable tie together, Bobs your uncle.
They each hold each other in place.
If you want to use the cable holder the holes are sized to take 3mm thread inserts, you will need your soldering iron
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!