Thingiverse
Ender3 Direct Drive E3D V6
door jan_michael
92
Downloads
69
Likes
2
Makes
Remix of bullseye motor mount for direct extruder system..
layer hight .20
shell. 1.2
infill 20-35%
support: anywhere 78 and 5%
Small PTFE tube is required
NOTE: Check the filament hole to make it sure if the filament go through
layer hight .20
shell. 1.2
infill 20-35%
support: anywhere 78 and 5%
Small PTFE tube is required
NOTE: Check the filament hole to make it sure if the filament go through
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!