Thingiverse
Ender3 foldable spool holder
door Antipaten
15
Downloads
5
Likes
0
Makes
My Ender3 v2 didn't fit to store under my desk with the filament holder mounted so I made a hinge to make it foldable for storage.
It's intended to work by reusing the two screws and t-nuts that are included with the printer. There are holes for an extra screw in the upper part of the hinge, but I have found that it's strong enough even if you use only one.
You need an additional M3x45 and an M3 nut for the hinge or you can just use a piece of 3 mm wire and a dab of glue in each end to keep it in place. You also need an M4 hex screw and a wing nut in the slot to lock the hinge in upright position.
It's intended to work by reusing the two screws and t-nuts that are included with the printer. There are holes for an extra screw in the upper part of the hinge, but I have found that it's strong enough even if you use only one.
You need an additional M3x45 and an M3 nut for the hinge or you can just use a piece of 3 mm wire and a dab of glue in each end to keep it in place. You also need an M4 hex screw and a wing nut in the slot to lock the hinge in upright position.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!