Ender3 G4 Led mount

This is a simple solution to add some light on the print bed; as the prints can't do any photosynthesis, a mini G4 1.5W led bulb would suffice.

You don`t need any supports, print it on the side; I used PLA, 0.2 mm; 20% fill.

One needs to drill a small hole (2-3 mm) in the printed part for the electric wires to come out; I snipped the led bulb legs a little bit shorter and then I have soldered the wires.

You need to take out the two screws from the profile, slide the part and put the screws back; it will fit loosely and you can adjust the position;