Ender3 pro 3point leveling and drill template.

3 point bed leveling for the ender 3 pro may work on the 3 if the bed heater pcb is the same.

Instructions
print drill template first make sure it lines up and MAKE sure their is a empty gap between the traces on the pcb to drill the hole. the top of the bed will require a countersink bit and a 4mm drill bit the screw head has to be flush. bolt on template then drill. the corner screws can be pushed up slightly then the magnet can be cut where the heads are to remve them. reuse m4 screws from bed. carriage bracked requires m4 screws and preferably nylock nuts to install i did not drill into the carriage its optional i the 2 corners should be stable enough.

print settings print with 5 walls 5 top and bottom 100 percent infill. pla is actually idea for this setup or a similar ridged material avoid plastics with flex like petg its low enough the heats not an issue.