Ender3v2 Linear Rod Y-Axis

Convert your Ender 3v2 Y-axis to linear rods!Enjoy smoother motion and a more consistent bed level on your Ender3v2FAST assembly, under 15 minutes!Minimal hardware is required:(4) M5x12 cap head screws(4) M5 Hex nuts(2) M4x12 cap head screws(2) M4 T-slot nuts(4) LM8UU Linear bearings(2) 8x400 Linear rods(All hardware can be easily found on Amazon) *NOTE: ABS, ASA or PETG is highly recommended for front and back brackets.PLA is fine for bed carriage, cover and stabilizers.Please boost 🚀 & rate⭐⭐⭐⭐⭐ if you like it!Assembly Instructions:Remove front tensioner. Remove the Y motor cover and end stop switch. Install the new Y motor cover using existing screw. Attach end stop switch to rear bracket as shown using existing screws. Install the (2) M4 screws and (2) T-slot nuts. Attach rear bracket to center extrusion and tighten screws, then press linear rods (2) into the bracket all the wa