EnderXY - Bed Wobble Begone

**Join the EnderXY community on Reddit:**
https://www.reddit.com/r/EnderXY/


I've made this as I've received a few messages on here asking if there was a way to fix the bed wobble without using triple-z. **This is untested as I use triple-z, but it should work and fix the issue completely.**

Remember to print 2040 linear rail guides before dissasembly to make the installation easier, I've included some to print (atleast 2).

You will lose 10mm on X as the motor had to be shifted, effectively moving the bed back 10mm so that the linear rail and lead screw are parallel, though this also depends on the thickness of the toolhead you are using.

_Note: If you are using the printed bracket and location designed by belt3dprinterkit then you will have to flip the bracket (check pictures)._

**Motor mount (Pic 7):**
- 4x M3x15mm (Socket or Pan head)
- 4x M3x10mm (Socket or Pan head)
- 4x M3x13mm (Socket or Pan head)
- 4x M3 spring nuts (Re-use stock)

**Arm (Pic 4, 5, 6):**