Enttec Open DMX Interface Enclosure

This is an enclosure for the Enttec Open DMX Interface. For this print you dont need a printer with dual extrusion, you first print out the lettering(the plate on top of the lettering is so smoul, that your printing software wont detect it), leave that on the print bed and print than the main part on top of the lettering. You only must be sure, that the positions on the print bed are right. The position of the part "UpperLettering" must be: x = 0, y =20, z = 0.The position of the main Part ("EnttecInterface") must be: x = --0.15, y = 1.05, z = 0. This technic will only work, if your print bed is perfectly leveled. On the picture of my second print you can see how it will look if your bed isn´t perfectly leveled. When the parts were printet, i smothed out the edges of the Bottom onf Front Part with a piece of sandpaper to have a better fit.
Assembling:
First you screw the interfce with two m3x10 screws in to the front part, make sure, that the shortest side shows to the top and that