Thingiverse
EOS OSC Encoder box
di jpgagnon73
1
Download
2
Likes
0
Makes
This is an enclosure for my EOS 4 Encoder OSC/USB controller.
Print at full size at your choice of quality. With supports. Supports are hard to remove from under display area, just use hot glue to hold your displays in place.
You will need 4 knobs. i print them at 106% size and the slide over the encoder very nicely. Test fit one before printing all of them.
The little wrench is designed to slide over the encoder shaft to tighten the nut.
use small screws to assemble.
the share hole in the back is for a standard USB A/B keystone jack.
Print at full size at your choice of quality. With supports. Supports are hard to remove from under display area, just use hot glue to hold your displays in place.
You will need 4 knobs. i print them at 106% size and the slide over the encoder very nicely. Test fit one before printing all of them.
The little wrench is designed to slide over the encoder shaft to tighten the nut.
use small screws to assemble.
the share hole in the back is for a standard USB A/B keystone jack.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!