Epee Wire Tip Insert

Print PETG
Required materials:
Soldering iron, solder, 2 jumper wires, shrink wrap (as small as you can get it)

Designed to be used with this print: https://www.thingiverse.com/thing:6959603

Assembly Instructions:
take two jumper wire and strip off a little less than an inch
if they are multi-ply, twist the end to make a rigid wire

put the smallest heat shrink you can find around the exposed wire up to ~.5cm from the tip. This is to insulate your wire from the ground, while keeping the wire diameter small enough to fit through the tip while it is attached to the blade. After heating the heat shrink (using a lighter or heat gun), repeatedly clamp the tubing down with pliers (while it is still hot) so that it appears flat.

insert both wires into the holes in the 3d printed part. If the holes are obstructed, use thin tweezers to open them up. You should insert the wires from the hollow side, so they poke out the flat side.
Make sure that the 'flat' sides of the shrink wrap are pa