Thingiverse
Epoxy paddle small
von johnjonhson
8
Downloads
6
Likes
0
Makes
Small epoxy mix paddle (20mm diameter) based on Paint Stir Drill Bit by birdshotbrad.
Openings in paddle are to make less drag.
Center shaft hole fits a 1/16" diameter rod for drill use. The metal rod will eliminate the vibration that would occur if the shaft were 3D printed. Mount upside down to scrape sides/bottom of epoxy container.
Openings in paddle are to make less drag.
Center shaft hole fits a 1/16" diameter rod for drill use. The metal rod will eliminate the vibration that would occur if the shaft were 3D printed. Mount upside down to scrape sides/bottom of epoxy container.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!