Thingiverse
Ergonomic Ring Pen
door CourageKenny
6
Downloads
27
Likes
1
Makes
This is not a remix, but was inspired by the "Finger Loop Hobby Knife" found on Printables.com. Similar concept with basic finger loop "ring" to help stabilize a short "bic" pen. It may be beneficial for some with limited dexterity or finger discomfort.
Parts required:
Bic Round Stick M pen
Tools Required:
Side Cutter Tool
Print Profile:
15% Infill
PLA
Print as oriented (circle/ring in full contact with build plate)
Should not require brim, but may depend on your printer/settings
No Support
Assembly (see pictures)
Make cut on Pen's shaft just after the "m". Length of shaft should = 44 mm
Cut Ink Tube so the length from ballpoint tip to end of ink tube = 60mm
Optional - Superglue the the ballpoint to the outer shaft tube to keep it from pulling out when flipping pen to cap it
Parts required:
Bic Round Stick M pen
Tools Required:
Side Cutter Tool
Print Profile:
15% Infill
PLA
Print as oriented (circle/ring in full contact with build plate)
Should not require brim, but may depend on your printer/settings
No Support
Assembly (see pictures)
Make cut on Pen's shaft just after the "m". Length of shaft should = 44 mm
Cut Ink Tube so the length from ballpoint tip to end of ink tube = 60mm
Optional - Superglue the the ballpoint to the outer shaft tube to keep it from pulling out when flipping pen to cap it
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
