ESC Case for Afro 12A

Here is a small stand alone case for the 12A Afro ESC.
It may be of use to some people. I was inspired by another case someone had made for a 30A version,
Part requires two M2 sized nuts to be pressed into the hex shaped holes after printing.
Also the hole for the status LED isnt present in the STL, I drilled that later.
I removed the wires from my ESC's (I wouldn't recommend this, bullet connectors were hard to align)
With this case you may also be able to add a small heat sink pad (one of those squishy ones) to the MOSFETs
The fit may be a little tight, so some filling will be required, especially where the servo wires exit.