Thingiverse
Robotics
Go to Model
escoBAR
8
Downloads
8
Likes
0
Makes
Antweight fighting robot (150 g), initial design based off shrapnel MK1 found on here, but no longer resembles the original other than some basic geometry.
Runs N20 motors, DYS 1806 motor 2300kV and pololu 40 mm wheels
As far as electronic I have run full blown arduino based wireless from nRF24 chips to off the shelf hobby electronics, so choose your own adventure!
Depending on print perimeters and infill you will have plenty of weight left over for electronics.
Uses M3 nylon nuts between the top and bottom chassis with screws to fix it.
Prolly heaps of details missing, if so let me know and ill fill you in with details!
Have fun fighting!
Runs N20 motors, DYS 1806 motor 2300kV and pololu 40 mm wheels
As far as electronic I have run full blown arduino based wireless from nRF24 chips to off the shelf hobby electronics, so choose your own adventure!
Depending on print perimeters and infill you will have plenty of weight left over for electronics.
Uses M3 nylon nuts between the top and bottom chassis with screws to fix it.
Prolly heaps of details missing, if so let me know and ill fill you in with details!
Have fun fighting!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
