Thingiverse
ESK8 handle
door filledk
38
Downloads
35
Likes
0
Makes
here is a Universal Skate/longboard Handle, designed for Electric skate and electric longboard in mind,
its designed so that it have little grooves/holes if you decide to glue it on your board instead of screwing it into your board (with is also doable due to the small screwholes i made)
i printed it in PLA and hotglued it to my board, and it actully holds well, due to the "hotness" of the hotglue and low melting point of PLA, (it bonds well with the hotglue)
also check out some of my other designs like my flashlight holder for longboarding> https://www.thingiverse.com/thing:2618614
some settings i used>
layerheight: 0.18mm
wall thickness: 3.5mm
top/buttom thickness 2mm
infill: 20%
nozzletemp: 205c
bedtemp: 55
reddit link:
its designed so that it have little grooves/holes if you decide to glue it on your board instead of screwing it into your board (with is also doable due to the small screwholes i made)
i printed it in PLA and hotglued it to my board, and it actully holds well, due to the "hotness" of the hotglue and low melting point of PLA, (it bonds well with the hotglue)
also check out some of my other designs like my flashlight holder for longboarding> https://www.thingiverse.com/thing:2618614
some settings i used>
layerheight: 0.18mm
wall thickness: 3.5mm
top/buttom thickness 2mm
infill: 20%
nozzletemp: 205c
bedtemp: 55
reddit link:
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!