Thingiverse
ESLT Talon Conversion 0.3
door KaneTheMediocre
6
Downloads
6
Likes
0
Makes
Latest version of ESLT talon conversion. Most noteworthy changes are replacement of screw mount with zip-tie slot, and the addition of a rear cover.
A crude strap-on draw-down system is included for use with horizontal pump grips-- "ESLTDrawDown4ClearWidget1". It replaces the system on fully printed foregrip in cases where the foregrip is a simple, not-3d-printed tube. That was never standard on ESLTs, but I needed it for my special clear ESLT. The amount of draw-down is correct for the ESLT but the size will probably need fixed for other blasters that may want to use this kit, which generally applies to anything pump action blaster where the air comes out the top of an (ideally 1.25" PVC) tube.
The normal forgrip system for this is not yet included in these files--Ryan had problems with the files I uploaded in the past not including crucial features that had been fixed on my end, so I need to remodel it from scatch to hopefully bypass those glitches.
The rear cover
A crude strap-on draw-down system is included for use with horizontal pump grips-- "ESLTDrawDown4ClearWidget1". It replaces the system on fully printed foregrip in cases where the foregrip is a simple, not-3d-printed tube. That was never standard on ESLTs, but I needed it for my special clear ESLT. The amount of draw-down is correct for the ESLT but the size will probably need fixed for other blasters that may want to use this kit, which generally applies to anything pump action blaster where the air comes out the top of an (ideally 1.25" PVC) tube.
The normal forgrip system for this is not yet included in these files--Ryan had problems with the files I uploaded in the past not including crucial features that had been fixed on my end, so I need to remodel it from scatch to hopefully bypass those glitches.
The rear cover
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!