ESP-12 breadboard adapter

Small box that can be wired up to allow an ESP-12 module (ESP8266 based) to fit into a breadboard. Each hole needs a wire pushed through it, then these should be pushed through the holes on the ESP module, and soldered in place.

The holes are 1.5mm diameter.

UPDATE: version 4 supports the contacts on the short side of the 12E and 12F modules. These are on a rather shallow angle, and the tunnels are quite close together, so you should probably test to make sure the wires aren't touching if using this version.

UPDATE2: version 3short is a 2mm high version, and 3narrow is narrower at the breadboard end so it only takes up the inner row of the breadboard.