ESP-32 C6 DevKit C V1.2 "Modular" Case

Parts Needed- 6x 10x2mm Magnets (if you choose to use them)Features- Wi-Fi Antenna is not enclosed to provide best reception possible. - Snap-fit Case Lid and Magnetic Base- Room to use DuPont terminal wires- Ventilation holes for the ESP-32 Chip- Honeycomb pattern to use less filament and allow viewing of pin connections- Pass-through buttons so you can still access the Reset and Boot buttons if you need to- RGB-LED hole & “isolator” ( I wanted to try and isolate the LED with a cone so that there was less light bleed into the rest of the chamber )- Labeled USB Connections (My X1C did not do well but YMMV, it's still somewhat legible but not perfect)- More lids and bases to come! ( I will add to this upload as I find the time to make the other parts ) Instructions- It can all be printed on one plate. - - Magnetic Base will need supports for the Magnet holes (Friction mounted, reinforced with Superglue)- After printing, Slide the Wi-Fi antenna into the wide slot at the rear, It 0.1m