Thingiverse
Electronics
Model downloaden
ESP-32 Dev Kit C V4 case with bracket
119
Downloads
109
Likes
0
Makes
Hi folks,
I have created a case for the new ESP-32 Dev Kit C V4 from AZ Delivery for a hobby project.
Maybe someone else can use it.
If you set the upper and lower thickness at housing to 0, the infill pattern comes out.
Then it will look the same for you.
This may allow a good cooling and it looks great.
It´s designed for the mounting-bracket-clip.
With the clip it is possible to stick in in place with double sided tape
You can reach all pins, buttons and the usb-port without removing the cover.
Have fun printing and make sure to post a make and some comments!
I have created a case for the new ESP-32 Dev Kit C V4 from AZ Delivery for a hobby project.
Maybe someone else can use it.
If you set the upper and lower thickness at housing to 0, the infill pattern comes out.
Then it will look the same for you.
This may allow a good cooling and it looks great.
It´s designed for the mounting-bracket-clip.
With the clip it is possible to stick in in place with double sided tape
You can reach all pins, buttons and the usb-port without removing the cover.
Have fun printing and make sure to post a make and some comments!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
