ESP12 Pogo Breadboard

This is an adapter to allow ESP-12 modules to be programmed or developed on a breadboard. It is an alternative version of the one I described at https://www.thingiverse.com/thing:2147460

The previous one fits standard solderless breadboards which have a central gap between the rows of 7.6mm. The width was kept to a minimum and meant that 2 spare holes were still available for connection to each esp-12 pin. This is OK for most applications.

This version uses a solderless breadboard divided into two pieces to allow a bigger gap. The adapter is changed to accommodate this by moving the headers outside the ESP pogo pins. This then allows up to 4 connection points per ESP pin which can be convenient for some uses.

The 3d prints allow spring pins to be used to match the 2mm spacing used on these modules. The pins mate through the holes on the module and allow the module to be just pushed in place. A retaining bar may be used to provide a more secure fit, although for quick programmi