Slicer Discord
ESP32 30 Pin Case for Lighting Projects – 3D-printbaar model van MakerWorld MakerWorld
Electronics

ESP32 30 Pin Case for Lighting Projects

32 Downloads
17 Likes
15 Makes
Model downloaden
This is a snap together case I designed for an ESP32 30 pin board, for mounting under kitchen cabinets. My plan is to use this for a WLED project using and ESP32 controller.The case is in 3 pieces, with the middle housing the ESP32 board. The lid has vents and pins that hold the board securely. The bottom creates a chamber for holding the wiring. There is a smaller hole in the front for the power cable to enter the case, and a larger hole in the back for the LED strip wires. I added two mounting tabs on the side so it can be mounted under kitchen cabinets. My test prints worked great and it snaps together with really good tolerances. I printed it using Creality White PETG, but it should work with other filaments. My print settings were standard quality at 0.2mm layer height. It doesn't need supports, and print time was about 1 hour.
Categorie
Electronics
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Gemiddelde betrouwbaarheid
Waarom?
3-delige montage · 0.20mm lagen
Supports 1/3
Montage 1/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA, ABS, PETG
Laaghoogte
0.2 mm
Geschatte printtijd
1 h
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie