ESP32 Breadboard Brace

If you have worked with many types of ESP32 or ESP32-S2 dev kit boards you know they do not always fit well onto either a standard breadboard or two attached standard breadboards if you want to assess to all the pins. This 3D print is a solution to that problem.

It also requires two standard full length (830 tie-point 4 power rail) breadboards.
The brace is used to combine a couple of standard breadboards, which have been hacked a bit as described below, for a perfect fit for working with many ESP32 or ESP32-S2 dev boards.

Step 1 involves printing the 3d print – a .stl file and the original .f3d (Fusion 360) file are both included.

Step 2 involves cutting the rightmost strip off the first standard breadboard and trimming away the tabs.

Step 3 involves trimming off the tabs from the second standard breadboard.

Step 4 involves removing the back protective film from the sticky pads on the bottom of each breadboard and placing the breadboard (hole side up) in the 3D pri