ESP32 Case for WLED 12V

This is an ESP32 case intended for 12V power setups that use a 5.5x2.1 mm power connector. It has holes for both the 12V power and the USB on one end, and a hole for the LED strip wires on the other end. The bottom snaps on and can be easily removed using the complient tabs on the side. Design goals for this were:Fit an Elegoo ESP32 prototyping board of dimensions 28.6 x 51.4 x 1.54 mmAllow for enough room in the case, including above the pins, for wires to fit comfortably.Allow for a 12V 5.5x2.1 mm barrel connector like you find on the end of a wire (not the ones with two screws on them).Allow enough room for two sets of wires to exit on the opposite end.Be a base for other ESP32 projects (e.g. I plan to do one for the barrel connector with two screws, too).Because it's using the prototyping board and making room for some extra wires, this is a little thicker than some other options, but that's intentional. If you don't like that, there are many others to choose from.