Slicer Discord
ESP32 Devkit V1 30 Pin CHONK Case – 3D printable model from MakerWorld MakerWorld
Electronics

ESP32 Devkit V1 30 Pin CHONK Case

29 Downloads
8 Likes
15 Makes
Go to Model
ESP32 Devkit V1 30 Pin CHONK CaseThis is a case for your ESP32 board with a few different choices for snap fit lids.There are many different types of ESP32 boards, check out the compatibility note section below to make sure it will fit your board. FeaturesSecure snap fit lid, your ESP32 won't be going anywhere.Access to header pins via the slots underneath.Only 12-13g of filament per body/lid combo and printed in just over 30 minutes. Lid ChoicesThere are a total of 6 lids for your choosing, I have placed each base & lid on separate plates so you can just print the plate for the lid you want.Normal Lid + ButtonsNormal Lid + No ButtonsHome Assistant Logo Lid + ButtonsHome Assistant Logo Lid + No ButtonsNo LED + ButtonsNo LED + No ButtonsI don't recommend the two “No LED” lids, these were designed for a friend who hates seeing the LED shine through. With no cut out this could cause higher temperatures and an early death for your ESP32 but I'm not your dad so use whatever lid
Category
Electronics
Source
MakerWorld
Published
Updated
What you need to print this: Advanced Low confidence
Supports 1/3
Assembly 2/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
PLA
Post-processing
Gluing
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection