ESP32-S2 Parallel TFT (Makerfabs) Case/Enclosure

**Case for Makerfabs Parallel TFT 3.5" (ESP32-S2)**

The enclosure is a snug fit, don't force the LCD pcb, it should fit perfectly (depending on how much your filament expands).

Attach LCD to bottom with four M3 x ~4mm screws then press fit into enclosure. Mine doesn't require any fixing method but you could always add a dot or two of of ca...

My test prints were sliced with Cura 5.1 with supports and are pretty close to perfect.

Version 5.2 modified to allow securing with M3 x 12mm screws.

Mike

Cura v5.2 reports error in stl file, I have rebuilt it, running a test print now... will replace file after testing print... Note, IdeaMaker can fix these errors...

KiCAD file available on request...