Thingiverse
esp32cam USB case
by AMusician
8
Downloads
0
Likes
0
Makes
This is a small box for an esp32cam, You can put it on a power bank to surveil your 3d printer.
The USB plug is soldered to the 5V and ground on the esp.
I would recommend putting some glue (at least for the camera) so that the esp doesn't move around
The Arduino sketch for this is the default "CameraWebServer.ino" from the sketch examples.
This design is also available on my tinkercad here:
https://www.tinkercad.com/things/60ILdgKPHxh https://www.tinkercad.com/things/iDrwzMcIjz2
If you have any questions, post them in the comments section.
The USB plug is soldered to the 5V and ground on the esp.
I would recommend putting some glue (at least for the camera) so that the esp doesn't move around
The Arduino sketch for this is the default "CameraWebServer.ino" from the sketch examples.
This design is also available on my tinkercad here:
https://www.tinkercad.com/things/60ILdgKPHxh https://www.tinkercad.com/things/iDrwzMcIjz2
If you have any questions, post them in the comments section.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!