ESP8266 And Mini Breadboard Support
by lithiil
5
Downloads
0
Likes
0
Makes
I made this support in order to keep my mini esp projects tidy.
This support is made to hold 1 ESP8266 and 1 Mini Breadboard.
Now, the ESP board that I am using is a clone but it should be similar to the real deal...measurements of the board are: 48mm x 25.5mm
It should be a snug fit so no screws or glue is required.
The print should finish in about 20 minutes with the settings mentioned here.
This support is made to hold 1 ESP8266 and 1 Mini Breadboard.
Now, the ESP board that I am using is a clone but it should be similar to the real deal...measurements of the board are: 48mm x 25.5mm
It should be a snug fit so no screws or glue is required.
The print should finish in about 20 minutes with the settings mentioned here.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
