Thingiverse
ESP8266 + Circuit Housing
por Virtual_Boi
2
Descargas
3
Likes
0
Makes
This housing is designed to hold a piece of protoboard with an ESP8266 board attached. Follow the bellow link to learn more about the set up and uses for this print.
The top and bottom halves are designed to snap together tightly, this is the type of housing you'd want to use for a project that is rarely tinkered with after being finished. If you plan to have to open the casing frequently, consider increasing the size of the top half by 1% in the slicer to allow for a looser fit. (I have not tested this but I'd assume it works)
This housing is part of a larger project that can be found here:
https://github.com/VirtualBoi/8x8-LED-Dot-matrix-Car-Window-Display
*NOTE*: there is space above the board to fit other components/wire. There is also a cutout in the back to hold and secure wire. (all shown in photos)
If you have any questions OR just liked the design, please drop a comment!
Happy printing!
The top and bottom halves are designed to snap together tightly, this is the type of housing you'd want to use for a project that is rarely tinkered with after being finished. If you plan to have to open the casing frequently, consider increasing the size of the top half by 1% in the slicer to allow for a looser fit. (I have not tested this but I'd assume it works)
This housing is part of a larger project that can be found here:
https://github.com/VirtualBoi/8x8-LED-Dot-matrix-Car-Window-Display
*NOTE*: there is space above the board to fit other components/wire. There is also a cutout in the back to hold and secure wire. (all shown in photos)
If you have any questions OR just liked the design, please drop a comment!
Happy printing!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!