Thingiverse
ESP8266 Lolin32 Case
door xzentorzx
28
Downloads
9
Likes
0
Makes
This is a case I made for this board (or boards with the same footprint):
https://de.aliexpress.com/item/ESP32-Rev1-wifi-bluetooth-board-based-ESP-32-4MB-FLASH/32814488554.html?spm=a2g0s.9042311.0.0.1ac84c4dBPpvN3
The lid is press fit and might be a tight one too. If its to tight sand off some of the bevel on the lid.
Supports are only needed for the access slot at the bottom. If you are confident in your printers bridging capabilities you might not need supports...
Change the orientation for it to lay flat on the buildplate.
https://de.aliexpress.com/item/ESP32-Rev1-wifi-bluetooth-board-based-ESP-32-4MB-FLASH/32814488554.html?spm=a2g0s.9042311.0.0.1ac84c4dBPpvN3
The lid is press fit and might be a tight one too. If its to tight sand off some of the bevel on the lid.
Supports are only needed for the access slot at the bottom. If you are confident in your printers bridging capabilities you might not need supports...
Change the orientation for it to lay flat on the buildplate.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
