Slicer Discord
ESP8266 OLED Case – 3D-Druckmodell von Thingiverse Thingiverse

ESP8266 OLED Case

von fredk1000
8 Downloads
11 Likes
1 Makes
Zum Modell
Hello,
This case is for a generic ESP8266 with built in OLED board.
It is a tweaked version of my Ideaspark ESP32 case.
For my board, there was about 0.5mm gap, so I just slipped in a piece of cardboard on the side to take up the slack to stop it rattling around as per picture.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen