ESPixNode Case w/PG7
von PaulTKennedy
9
Downloads
5
Likes
0
Makes
Remixed from hitekstuff's design.
Added nubs to snap the board into.
Swapped orientation of mounting hole.
Added full enclosure and hole for PG7 gland—shared output for DC pigtail and JST-SM connector.
Added graphics to lid.
As shown in pictures, everything is a TIGHT fit—be very careful sliding the lid over the wires.
NOT WATERPROOF, just using the PG7 as a strain relief!
Added nubs to snap the board into.
Swapped orientation of mounting hole.
Added full enclosure and hole for PG7 gland—shared output for DC pigtail and JST-SM connector.
Added graphics to lid.
As shown in pictures, everything is a TIGHT fit—be very careful sliding the lid over the wires.
NOT WATERPROOF, just using the PG7 as a strain relief!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!