Essential oil stand (expandable)

Made this for my good lady to keep her oils together because they were doing my head in lying around everywhere.......You can use it for anything that'll fit into the +/- 26mm diameter holes (6 per tier = 12 in total per stand or 24 if you double it up).

I may make one for humbrol model paints too (just need to make holes bigger)

I have included the sketch up model to allow you to make your own changes too. There are two types of base, male and female.It doesn't matter what you print unless you are looking to connect another stand 'back to back'. You will need to glue this together epoxy is the ultimate but superglue or plumbers waste-pipe glue (especially with abs) also work very well.

Print any way you want, the model is forgiving so I'd just go with fast and default settings. You'll get good results whatever you do.

When using ABS I like Polypipe SC250 solvent cement, it fuses your surfaces together and nearly makes it one solid piece (careful though it kinda melts pla