Thingiverse
eStep Ruler
von oldmogy
10
Downloads
8
Likes
0
Makes
yet another eStep Ruler , and why?
... because I can :)
You could print this is anything you want (maybe even TPU), but I tend to print in ABS+, simply because it so HOT at this time of year, here in Brisbane, Oz. ABS is perfect to print in this climate.
This ruler is really easy to use and works with different filament feed types.
Just place the T shaped end against the filament extruder then make two marks, one at 100mm, then another at the end of the rule (120mm). Set your printer to extrude 100mm of filament and see where it ends up.
The mark at 120mm is for the case when you are over extruding, so you measure from the end backwards to give you a number for the eStep equation.
... because I can :)
You could print this is anything you want (maybe even TPU), but I tend to print in ABS+, simply because it so HOT at this time of year, here in Brisbane, Oz. ABS is perfect to print in this climate.
This ruler is really easy to use and works with different filament feed types.
Just place the T shaped end against the filament extruder then make two marks, one at 100mm, then another at the end of the rule (120mm). Set your printer to extrude 100mm of filament and see where it ends up.
The mark at 120mm is for the case when you are over extruding, so you measure from the end backwards to give you a number for the eStep equation.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!