Slicer Discord
#eternaltransmitter – 3D-Druckmodell von Thingiverse Thingiverse

#eternaltransmitter

von Lehaiver
54 Downloads
124 Likes
0 Makes
Zum Modell
Alteration of the transmitter (CGM system).
The transmitter has a limited lifetime (about 1 year), after it must be replaced. The cost of the new device, sometimes is "unaffordable" for most people with diabetes and their families.
Alteration it is an ability to use the transmitter for an unlimited time.

!!!ATTENTION!!!:
Сheck the remaining battery charge of transmitter, and if it is less than 2 volts, do not use this alteration!!! Otherwise, they may swell and cause damage the transmitter body!!! Is better to replace the internal batteries completely.
In this alteration is better to use CR2032. For proper charge from LiR2032, limiting element is needed to reduce charging voltage and amperage!!! Otherwise, internal battaries may swell and cause damage the transmitter body!!!.
iDO IT AT YOUR OWN RISK!

How to:
Part 1: fixture - https://youtu.be/p_qOKHxJRSs
Part 2: pads - https://youtu.be/-Ta06eBPvQ8
Part 3: holder - https://youtu.be/2WrytWZIp0I

Please give feedback )
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

Lehaiver veröffentlicht auch auf

41 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen