Thingiverse
Etha 2 Magnet Trigger Mod
5
Downloads
2
Likes
0
Makes
Saw a Youtube video and Reddit post about a magnet trigger mod. Unfortunately the creator wasn't reachable anymore. Therefore I created this by myself via tinkercad.
I used a Neodym magnet with 6mm Ø and 2mm height, glued it to the 3d print (Picture 1) and replaced with the original trigger Spring (Picture 2).
On the trigger itself I used a 5mm Ø x 1mm height magnet. I am using the Infamous ETHA2 Deuce Trigger instead of the original one (Picture 3), but this should also work with the original trigger.
This is my first upload and I am quite new to 3d printing. Valuable feedback appreciated.
I used a Neodym magnet with 6mm Ø and 2mm height, glued it to the 3d print (Picture 1) and replaced with the original trigger Spring (Picture 2).
On the trigger itself I used a 5mm Ø x 1mm height magnet. I am using the Infamous ETHA2 Deuce Trigger instead of the original one (Picture 3), but this should also work with the original trigger.
This is my first upload and I am quite new to 3d printing. Valuable feedback appreciated.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
