Thingiverse
Ethernet Smooth Stepper Enclosure
von BitBuilder
7
Downloads
10
Likes
1
Makes
Small changes to the original design:
Added mounting tabs to easily screw the case to a board.
Also, for some unknown reason, The bottom design omitted the screw holes for the lid, which I re-added.
The lid is unchanged so get it from the original design.
Otherwise, it's the same.
Thanks to XeonDesigns for creating the original!
Added mounting tabs to easily screw the case to a board.
Also, for some unknown reason, The bottom design omitted the screw holes for the lid, which I re-added.
The lid is unchanged so get it from the original design.
Otherwise, it's the same.
Thanks to XeonDesigns for creating the original!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!