ethirteen e spec chainguide slider replacement

This is a replacement for the slider on your e*thirteen e*spec chain-guide - its two parts and will need the original mounting bolt from the extant unit - and two m3x10mm self tapping screws. you could probably tap or sink some inserts into the unit, but it might require some post processing work. I'm sure you can make it work!

I printed in overture PLA with 100% infill.

I've given this version a pretty good wringing out, and so far its good - will update if i find that it allows the chain to drop! The first version was a bit flimsier and did allow for dropping but this has been good so far.