Thingiverse
Eufy "Wireless" 25º mount
von bytespider
37
Downloads
26
Likes
0
Makes
I wanted to connect my Eufy Doorbell to wires and screw holes from the existing doorbell.
Rather than redesign the whole part, I decided that I would combine the 15º mounting bracket with and additional 25º wedge and get the 40º I wanted.
Installation:
1. 2 nuts are recessed into the back of the 3D printed part
2. Attach the 3D printed part to the existing holes
3. Attach the Eufy supplied doorbell holder and the 15º wedge to the 3D printed part using suitable hardware
4. Continue Eufy doorbell installation.
Rather than redesign the whole part, I decided that I would combine the 15º mounting bracket with and additional 25º wedge and get the 40º I wanted.
Installation:
1. 2 nuts are recessed into the back of the 3D printed part
2. Attach the 3D printed part to the existing holes
3. Attach the Eufy supplied doorbell holder and the 15º wedge to the 3D printed part using suitable hardware
4. Continue Eufy doorbell installation.
bytespider veröffentlicht auch auf
42 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!