MakerWorld
Other House Models
Model downloaden
Eureka Mignon Grinder Split Hopper (For two types)
12
Downloads
6
Likes
4
Makes
To allow for normal and decaf beans I created a hopper based on the original that comes with the Eureka Mignon ORO XL.Instead I put a wall between the middle and some tabs to control the flow of beans from each section.Note: it may fit the other Eureka grinders but not tested it as I only have the one. Would love to know if the sizings are same (which I assume they are)V2 (In progress)The current design, the space between the “tabs” and the space for the grinder fits about 14g of beans in it.I'm designing a new version to add a little more space below so that I can made one “full” shot around 17-18g. This allows you to open and close each tap and act as a very basic dose.Print Settings.20Material - PETG or PLA ( I choose PETG because of the food safety)15% Gyroid Infill - you could lower or higher this depending on how sturdy you want it.Support onBuild plate onlyTree - SlimBambuStudio SettingsWhen printing in Bambu Studio I had some layer adhesion issues with the curved wall becau
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!