Thingiverse
EV Cable Hanger / Hook
von tcchan
4
Downloads
8
Likes
0
Makes
A simple design for a small issue. An EV charging cable hanger/hook to avoid cable getting ' dirty' while charging.
The print can take some time depending on the print speed of your printer. On a CR6-SE it took almost 12 hours to print (11:45). I had it also printed on a BambuLab P1S and it only took around 3 hours.
I advise using a brim to avoid possible warping with PETG, especially on a ' slow' printer. And (painted) support is only needed on the top part of the hook
The print can take some time depending on the print speed of your printer. On a CR6-SE it took almost 12 hours to print (11:45). I had it also printed on a BambuLab P1S and it only took around 3 hours.
I advise using a brim to avoid possible warping with PETG, especially on a ' slow' printer. And (painted) support is only needed on the top part of the hook
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
