MakerWorld
Electronics
Model downloaden
EV Charging Cable Wall Mount Clip
72
Downloads
13
Likes
42
Makes
A clip with a 19mm diameter for a EV charging cable. Specifically designed this for use with JuiceBox (Gen 2) cables so I can route/mount it in a way that can store the end of the cable cleanly away from the chargers base station. Ideally you would print in the orientation provided so no supports are needed, but you can adjust if your needs change, and even scale up/down if needed. The screw hole is designed for 5x22 screws, but could esily be modified within something like TinkerCad.Boost Me
CorneliousJD publiceert ook op
18 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
