Thingiverse
EV3 Mindstorms Touch Sensor
von spanland
22
Downloads
22
Likes
0
Makes
Printed EV3 Touch Sensor. It designed for small switch which I have, so for your purpose you should redesign for another one. RJ25 connector I made from RJ45 connector of broken ethernet switch. Also it need two pices of springs diamneter 4mm.
Printed on delta Micromake printer. Layer 0.1mm Extruder 0.3mm
Printed on delta Micromake printer. Layer 0.1mm Extruder 0.3mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
