Thingiverse
EVA2 kit for BLV MGN Cube
por tetele
91
Descargas
73
Likes
2
Makes
Mounting kit for the EVA v2.4 on the BLV MGN Cube printer.
Official page of this extension kit is here https://contrib.eva-3d.page/printer-compatibility/blv-mgn-cube/
The standard EVA hotend carriage was designed for printers using 9mm belts with a different orientation than the BLV MGN Cube. This kit provides all the parts needed to use the EVA on the BLV MGN Cube.
The kit only supports hotends and extruders that are compatible with the original universal face (e.g. not the Titan Aero, which has a dedicated face). It also only supports 6mm timing belts.
A note on belt parallelism and dimensional accuracy:
Dimensional accuracy is slightly affected towards the left and right site of the print. The amount with which it is affected is very very small, however.
In my case, at the edge of the bed, the distance between the belts is ~33mm instead of the standard 24mm, at a carriage distance of 81mm from the pulleys. That means that the belt angle is arctg((33-24)/2/81) = 3.18 de
Official page of this extension kit is here https://contrib.eva-3d.page/printer-compatibility/blv-mgn-cube/
The standard EVA hotend carriage was designed for printers using 9mm belts with a different orientation than the BLV MGN Cube. This kit provides all the parts needed to use the EVA on the BLV MGN Cube.
The kit only supports hotends and extruders that are compatible with the original universal face (e.g. not the Titan Aero, which has a dedicated face). It also only supports 6mm timing belts.
A note on belt parallelism and dimensional accuracy:
Dimensional accuracy is slightly affected towards the left and right site of the print. The amount with which it is affected is very very small, however.
In my case, at the edge of the bed, the distance between the belts is ~33mm instead of the standard 24mm, at a carriage distance of 81mm from the pulleys. That means that the belt angle is arctg((33-24)/2/81) = 3.18 de
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
