Evergreen insert clips and player bins

This includes a model for player pieces print and one for the leaf that fit in the existing insert. These clips hold down the two separator walls and prevents pieces from from migrating into other sections underneath them. I also glued the sides of the walls together. But it works very well and is very solid. 1. Empty the box. I recommend taking everything out but the smaller bits. Cover it and flip it over so all the pieces are in the lid.2. Take out the insert and flip it over making note of the ends of the two removable walls.3. For each of the slits where the walls go into the side of the insert, take a clip and orient it so the protruding section slides into the open slot while also sliding the top of the wall into the groove on the other side of the clip. When you push the insert back into its set shape the wall will be held down by the clip. It's better to complete both walls on the same side. The slowly turning it 180 degrees to work on the other. 4. As long as you hold the