Evinrude Throttle Handle

This is the handle mechanism for throttle control on Evinrude 9.9 outboard motor. This design was done in order to avoid high costs for the same cheap stock parts online. It turned out a bit bulky given the design requirement and desired strength, but it gets the job done.

Track: The most important part of this design which converts the radial force applied to the handle into linear force and motion applied to the throttle mechanism.

Caps: Caps for the top of the pin in order to not destroy the track and keep the pin tracking smoothly. Two parts are available with different diameter holes to account for printer tolerance variations.

Guide: Guide piece that goes around the pin and into the slot on the tiller. In order to keep the pin tracking vertically. Two parts are available with different diameter holes to account for printer tolerance variations.

Handle: The "sleeve" part of this is self-explanatory. Printed vertically without supports.

As far as the pin goes... I