Evolution Maverick D5 - Trunk Lid Held Open

I got tired of holding the trunk open with one hand while getting stuff in/out with the other. This is a quick print to solve that. The cord loops over the trunk finger latch to hold it open. No parts flailing in the wind while you drive around. Printed parts on the side with support. They don't look as pretty, but hopefully they will be sturdier. Used PLA since that was already loaded in the printer. If this part breaks down in the sun, chances the shock cord is spent as well. It's another $0.11 to print a new set. In addition to the printed parts, you'll need (2) M8x25 screws. These screw into the screw holes the Golf Bag holder uses.13 in of shock cord. I used a 4mm piece I had in the garage.